1-3/4" Panhead Shotgun Exhaust Systems For 1958 - 1964
These complete systems fit 1958–1964 swingarm frames with electric or kickstart and swing-out kicker ONLY. They will not fit with a large FLH battery. They all have slider channels so you can use a Paughco #718J bracket (sold separately) to install the rear pipe (see page 263). A heat shield for the rear pipe is highly recommended.
721D1-40 40"-long Slash Cut drag pipes (shown below on bike)
721D1GM 38"-long Goose Cut muffler set
721D1M 38"-long Slash Cut muffler set
721D1TM 38"-long Tapered muffler set
412D1R Rear heat shield for Paughco #721D1 series pipe sets (shown below on bike)
718J Hanger bracket for the rear pipe on Paughco #721D1 series pipe sets (shown below
on bike)
Special
Notes
:1) Drag pipes are not recommended for use on the street
.2) These pipes have less ground clearance than original equipment and may scrape on hard right hand turns
. Do not use these pipes unless the front end is extended at least
4" longer than stock or serious injury may result
.3) See page
247 for
P-clamps and frame rail clamps to install these pipe sets
.4) See pages
349-353 for photos of the heat shields for these pipe sets
.